Troubleshooting - AEG BEB231011M Notice D'utilisation

Step 8
Step 9
The screen-printing zone must face the in‐
ner side of the door. Make sure that after
the installation the surface of the glass
panel frame on the screen-printing zones
is not rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.
12.4 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Turn off the oven. Wait until
the oven is cold.
Back lamp
Step 1
Step 2
Step 3
Step 4

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
Clean the glass panels with water
and soap. Dry the glass panels
carefully. Do not clean the glass
panels in the dishwasher.
After cleaning, install the glass
panel and the oven door.
Before you replace the lamp:
Step 1
Turn the glass cover to remove it.
Clean the glass cover.
Replace the lamp with a suitable 300 °C heat-resistant lamp.
Install the glass cover.
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Step 2
Disconnect the oven from
the mains.
13.1 What to do if...
In any cases not included in this table
please contact with an Authorised
Service Centre.
ENGLISH
Step 3
Put a cloth on the bottom of
the cavity.
25
A
B