Zehnder ComfoAir 70 Instructions De Montage page 10

External control panel
cable through the cover frame first.
Carefully push the correctly
positioned function unit with the
snap-in feet in the lateral position
into the in-wall frame until the
cover frame is fixed in place.
ComfoSpot 50
Disconnect the plug-in connector
part with the screw-type terminals
and connect the wires of the on-
site cable. Make a note of the
colour coding.
10
Guide the connecting cable
with the wire ends through the
openings of the bottom cover to
the control board.
Connect the wires of the
connecting cable to the BUS
X7 spring-type terminals on the
control board according to the
colour coding.
Install the connecting cable in the
designated cable recess of the
EPP housing and close the control
board with the PVC cover.
After inserting the unit into the wall
mounting pipe, connect both parts
of the plug-in connector together
in the area of the cable entry point.