Appliance Dimensions; Recess Dimensions; Cabinet Door - V-ZUG Komfort 60i Notice D'installation

Do not install the appliance in a location where it is exposed
q
to direct radiation of the sun, next to a cooker, heater and
similar.
Do not install the appliance alone: it is best to work together
q
with two or more people.
The more R 600a refrigerant there is in the appliance, the
q
larger the room in which the appliance is standing needs to
be. In rooms that are too small, a flammable mix of gas and
air may be created if there is a leak. According to the EN 378
standard, every 11 g of R 600a refrigerant requires at least
1 m space in the room for the appliance. The amount of
3
refrigerant in your appliance is on the type plate inside the
appliance.
If the appliance is installed in a very damp environment,
q
condensed water may form on the outside of the appliance.
Always make sure that there is good ventilation - both at air
inlet and outlet - at the site of installation.
After installation:
u Remove protective films, adhesive tapes and transport lock
parts etc.
Note
u Clean the appliance (see
Chapter "Cleaning the appliance").

4 Appliance dimensions

Fig. 1

5 Recess dimensions

This is a base unit and should be installed under a worktop.
The kitchen units must be fitted according to the specifications,
allowing sufficient ventilation to ensure the equipment works
properly.
* Depending on model and options
Operating Instructions,
Appliance dimensions
Fig. 2
The specified energy consumption applies to a unit depth of
560 mm. The appliance will work properly at a unit depth of 550
mm, but at a slightly higher energy consumption.
u Check the wall thickness of adjacent cabinets: It must be
min. 16 mm.
u Align the cabinets with a spirit level and a try square. If
necessary level them by putting something underneath
them.
u Ensure that the floor and the side panels of the cabinet are
at right angles to each other.

6 Cabinet door

A door is required for the kitchen furniture.
-
- The door must be at least 16 mm and maximum 19 mm
thick.
- There must be a gap of at least 3 mm between the door and
the cupboard door above (if there is one).
- The width of the cabinet door depends on the style of the
kitchen and the size of the gap between the cupboard door
panels. Normally a vertical gap of 3 mm should be left
between the cabinet doors.
- If there are more cupboards the upper edge of the cabinet
door should be at the same height as the doors on the next
cabinet.
- The cabinet door must be fitted flat with no tension.
NOTICE
An excessively heavy unit door can cause potential damage!
If the unit door is too heavy, we cannot rule out damage to the
hinges, which may compromise the use of the unit.
u Before installing the unit door, ensure the door does not
exceed the permissible weight.
Appliance model
Komfort 60i
Maximum unit door
weight
10 kg
31