Adjusting The Recording Level; Recording The Mixed Sounds (Microphone Mixing) - Sony MXD-D1 Mode D'emploi

Adjusting the Recording Level

When recording sound sources selected by the REC
SOURCE SELECTOR buttons, adjust the recording
level before starting recording.
You cannot adjust the recording level during digital
recording.
REC SOURCE SELECTOR
§
· P p
1
Do steps 1 to 5 in "Recording on an MD
Manually" on page 25.
2
Press one or two of the REC SOURCE SELECTOR
buttons to select the sound source you want to
record.
3
Play the portion of the sound source with the
strongest signal level.
4
While monitoring the sound, turn REC LEVEL to
adjust the recording level so that the OVER
indication (red) of the peak level meters does not
turn on.
If the peak level meters do not move much even
after turning REC LEVEL, adjust MIX BALANCE.
5
Stop playing the sound source.
6
To start recording, do the procedure starting from
step 7 (Analog recording) in "Recording on an
MD Manually" on page 26.
REC LEVEL
§
≠ AMS ±
• •
0 )
MIX BALANCE
Recording on MDs
Recording the Mixed Sounds
(Microphone Mixing)
You can "mix" sound by playing the CD player
section, sound sources connected to the unit, or singing
or speaking into a microphone (not supplied).
The mixed sounds can then be recorded on an MD.
You can also enjoy cross-fading with the CD player
section and connected sound source.
OPEN/CLOSE § r REC
§
· P p
REC SOURCE SELECTOR
1
Connect a microphone (not supplied) to the MIC
jack.
2
Turn on the amplifier and set the source selector
to the position for the sound source you want to
record.
When you want to record from the CD player
section, press OPEN/CLOSE § and insert a CD.
3
Insert a recordable MD.
4
Press r REC.
The MD deck section stands by for recording.
5
Press one or two of the REC SOURCE SELECTOR
buttons to select the sound sources you want to
mix.
You can select up to two sound sources.
MIX BALANCE
§
≠ AMS ±
• •
0 )
MIC
(Continued)
27 EN