Sony MXD-D1 Mode D'emploi page 27

Recording on MDs
When "LEVEL-SYNC" is displayed during analog
recording
The track number is written in sync with the level of
the input signal from the sound source. In other
words, if the input signal from the sound source is
continuously at or below a certain fixed level for
several seconds, a track number is written the next
time the input signal exceeds that level (see "Marking
track numbers automatically" on page 28).
Track
1
number
A
Original
If the level does not drop below a certain fixed
level continuously for several seconds because
the interval between tracks is short, etc., no
track number is written.
Track
1
number
A
Recorded
MD
If the level does drop below a certain fixed level
continuously for several seconds, even if in the
middle of a track, a track number is written.
Note
When you select MIC with REC SOURCE SELECTOR, the
track number is not written automatically even if "LEVEL-
SYNC"appears in the display.
Other cases
Only one track number is written at the start of a
recording. The entire recording is counted as one
track. You can mark track numbers during recording,
either manually or automatically (see "Marking track
numbers manually" on page 28).
Track
1
number
A
Original
Only one track number is written at the
start of a recording.
Track
1
number
A
Recorded
MD
24 EN
2 3
4
B C D
.
2 3 4
C
B C D
4
3
2
B C D
.
2 3
4
B C D
When "TOC" flashes in the display
Do not move the unit or pull out the AC power cord. If
you do, the recorded material may not be saved
normally because the MD deck section is updating the
Table Of Contents (TOC).
Do not disconnect the AC power cord immediately after
recording
If you do, the recorded material may not be saved to
the MD.
To protect an MD against accidental erasure
To make it impossible to record on an MD, slide the tab
in the direction by the arrow, opening the slot.
"Protected" appears in the display if you attempt to
record on the MD. To allow recording, close the slot.
Rear of the disc
Slide the tab in the
direction by the arrow
Record-protect tab