Getting Started; Unpacking; Hooking Up The System - Sony MXD-D1 Mode D'emploi

Getting Started

Getting Started

Unpacking

Check that you received the following items:
• Audio connecting cords (2)
• Optical cable (1)
• Remote commander (remote) RM-D11M (1)
• Sony SUM-3 (NS) batteries (2)
Inserting batteries into the remote
You can control the unit using the supplied remote.
Insert two R6 (size-AA) batteries by matching the +
and – on the batteries. When using the remote, point it
at the remote sensor g on the unit.
When to replace batteries
With normal use, the batteries should last for about six
months. When the remote no longer operates the unit,
replace all the batteries with new ones.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
• If you don't use the remote for an extended period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
4 EN

Hooking Up the System

Overview
This section describes how to hook up the unit to an
amplifier or other components such as a DAT deck.
Be sure to turn off the power of each component before
connection.
REC TAPE
OUT IN
Amplifier
DAT deck, or
MD deck, etc.
: Signal flow
ç ç ç ç ç
Preparing the connecting cords
• Audio connecting cords (supplied) (2)
White
(L)
Red
(R)
• Optical cable (supplied) (1)
to a wall outlet
DIGITAL
OPTICAL IN
White
(L)
Red
(R)