Sony MXD-D1 Mode D'emploi page 12

When "TOC" flashes in the
display
The player is currently updating
the Table Of Contents (TOC).
Do not move the unit or pull out
the AC power cord.
If you do, recorded material may
not be saved normally.
Do not disconnect the unit from the power source immediately after
recording
If you do, recorded material may not be saved to the MD. To save the material,
after recording, press EJECT § to take out the MD or change the player to
standby by pressing POWER. "TOC" will flash in the display at this time.
After "TOC" stops flashing and goes out, you can pull out the AC power
cord.
To Press
p.
Stop recording
REC PAUSE or P. Press the button again or press
Pause recording*
· to resume recording.
OPEN/CLOSE § after pausing playback.
Take out the CD
EJECT § after stopping recording.
Take out the MD
* Whenever you pause recording, the track number increases by one. For example, if
you paused recording while recording on track 4, the track number increases by
one and recording continues on the new track when restarted.
To protect an MD against accidental erasure
To make it impossible to record on an MD, slide the tab in the direction by the
arrow, opening the slot. To allow recording, close the slot.
Rear of the disc
Basic Operations
Record-protect tab
Slide the tab in the
direction by the arrow
9 EN