Jennair Rise JGRP648HL Instructions D'installation page 35

12. Replace oven bake burner electrode inside bracket.
B
A
A. Oven bake burner electrode
B. Oven bake burner electrode bracket
13. Reinstall the oven bake burner and oven bake burner
screws. See Step 5 for illustration.
Replace Oven Bake Burner Cover
1. Align rear shoulder screw mounting holes (keyholes) on the
oven bake burner cover with shoulder screws in the bottom
of the oven.
A. Shoulder screw mounting holes (keyholes)
B. Shoulder screws
2. Drop cover and slide to left or right to slide shoulder screws
into narrow ends of keyholes, and lock into place.
Complete Installation
1. Refer to the "Make Gas Connection" section for properly
connecting the range to the gas supply.
2. Refer to the "Electronic Ignition System" section for proper
burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the "LO" setting for
each range burner.
Checking for proper range burner flame is very important.
The small inner cone should have a very distinct blue flame
1/4" (6.4 mm) to 1/2" (1.3 cm) long. The outer cone is not as
distinct as the inner cone. Propane gas flames have a slightly
yellow tip.
3. Refer to "Complete Installation" in the "Installation
Instructions" section of this manual to complete this
procedure.
A
B
A
A. Bake burner cover
35