Jennair Rise JGRP648HL Instructions D'installation page 19

To Adjust Flame Height:
1. Unplug range or disconnect power.
2. Remove burner grates.
3. Remove the control knobs.
4. Open the oven door and remove the two screws on each
side of the range that hold the control console in place.
NOTE: Make sure to leave oven door open or the control
console will not rest in the side brackets properly once it is
detached.
5. Pull up on the control console and let it drop forward into the
notched console brackets on each side.
A
A. Control console bracket
6. Put a control knob onto the valve stem of the burner you
want to adjust.
7. Turn the control knob to LO and, using a butane extension
lighter, light the burner.
8. Remove the control knob.
9. Use a 1/8" x 4¼" (3 mm x 100 mm) flat-blade screwdriver to
adjust the flame height. Tighten screw to reduce flame
height. Loosen screw to increase flame height.
A
A. Single flame burner adjustment screw (on right side of valve)
B. Dual flame burner adjustment screw (on left side of valve)
10. When finished adjusting the flame height, put a control knob
back onto the valve stem and turn off the burner.
11. Remove the control knob.
12. Repeat steps 6 through 13 for any other burners that
need adjustment.
13. Lift up on the control console and set it back into place. For
a proper fit, the flange of the control console must hook over
the lip on the front of the range cooktop.
A
B
A. Control console flange
B. Front lip of range cooktop
14. Check that the control console is flush with the top edge of
the range.
A
A. Flush with range top
15. Replace the two screws on each side of the control console.
16. Replace the control knobs.
17. Replace burner grates.
18. Test the flame by turning the control from LO to HI, checking
the flame at each setting.
B
19