Jennair Rise JGRP648HL Instructions D'installation page 23

Replace Oven Bake Burner Cover
1. Align notches on the oven bake burner cover with shoulder
screws in the bottom of the oven.
A B
A. Cover notches (4)
B. Shoulder screws (4)
2. Lower cover, and slide to left or right to slide shoulder
screws into the narrow ends of the notches, then lock
into place.
A
A. Bake burner cover
Convert Oven Broil Burner (30" [76.2 cm] and 36"
[91.4 cm] models and the right oven cavity on 48"
[121.9 cm] models)
1. Using a 1/4" (6.4 mm) nut driver, remove broil burner screw.
Set aside with side igniter positioned on the right.
A
B
C
A. Broil burner screw
B. Broil burner
C. Broil burner orifice hole
2. Pull the broil burner toward you until it slides out of the hole
A
3. Apply masking tape to the end of a 1/4" (6.4 mm) nut driver
B
4. Gas orifice studs are stamped with a letter and a number.
5. Place Natural gas orifice in plastic parts bag for future use,
6. Replace the broil burner in the hole in the oven back with the
7. Reinstall the oven broil burner screw. See Step 1 for
in the oven back, and pull the electrode out of the bracket.
The broil burner will hang down in the back of the oven while
you change the orifice.
A
B
A. Grasp electrode here.
B. Bracket
to help hold the gas orifice spud in the nut driver while
changing it. Insert nut driver into the gas opening, and press
down onto the gas orifice spud, then remove by turning the
gas orifice spud counterclockwise and lifting out. Set gas
orifice spud aside.
A B C
A. Oven back
B. Broil burner orifice
C. Broil burner orifice hole
Install the Number 97 oven broil burner orifice spud.
and keep with package containing literature.
broil burner assembly inside the broil burner electrode hole
as illustrated.
A. Broil burner orifice hole
B. Broil burner electrode
C. Broil burner electrode hole
illustration. The screw is aligned with the hole when
a click sounds.
Broil burner hanging
in back of oven
A B C
23