Install Anti-Tip Bracket - Jennair Rise JGRP648HL Instructions D'installation

Install Anti-Tip Bracket

WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
1. Determine which mounting method to use: floor or wall.
If you have a stone or masonry floor, you can use the
wall mounting method.
2. Determine and mark centerline of the cutout space. The
mounting bracket must be installed on the left side of the
cutout. Position mounting bracket in cutout as shown in the
following illustration.
Measurement B:
30" (76.2 cm) ranges: 13" (33.0 cm)
36" (91.4 cm) ranges: 16" (40.6 cm)
48" (121.9 cm) ranges: 22" (55.9 cm)
Measurement C:
Optional distance from back wall. If back wall is constructed
of a combustible material and a backguard is not installed, a
6" (15.2 cm) minimum clearance is required for all models.
Install anti-tip bracket accordingly.
C
B
A. Centerline
B. Centerline of cutout to outside
edge of anti-tip bracket
C. Back wall to back of range
12
3. Drill two 1/8" (3.0 mm) holes that correspond to the bracket
4. Using a Phillips screwdriver, mount anti-tip bracket
5. Move range close enough to opening to allow for electrical
6. Continue installing your range using the following
A
holes of the determined mounting method. See the following
illustrations.
Floor Mounting
B
A
A. #12 x 1 ⁄ " (4.1 cm) screws
5
8
B. Anti-tip bracket
Wall Mounting
B
A. #12 x 1 ⁄ " (4.1 cm) screws
5
8
B. Anti-tip bracket
to the wall or floor with the two #12 x 1
screws provided.
Depending on the thickness of your flooring, longer screws
may be necessary to anchor the bracket to the subfloor.
Longer screws are available from your local hardware store.
connections to be made. Remove shipping base, cardboard,
or hardboard from under range.
installation instructions.
A
⁄ " (4.1 cm)
5
8