Jennair Rise JGRP648HL Instructions D'installation page 33

2. Pull the broil burner toward you until it slides out of the hole
in the oven back, and pull the electrode out of the bracket.
The broil burner will hang down in the back of the oven while
you change the orifice.
A. Grasp electrode here.
B. Bracket
3. Apply masking tape to the end of a 1/4" (6.4 mm) nut driver
to help hold the gas orifice spud in the nut driver while
changing it. Insert nut driver into the gas opening, and press
down onto the gas orifice spud, then remove by turning the
gas orifice spud counterclockwise and lifting out. Set gas
orifice spud aside.
A B
A. Oven back
B. Broil burner orifice
C. Broil burner orifice hole
4. Gas orifice studs are stamped with a letter and a number.
Install the Number 148 oven broil burner orifice spud.
5. Place Propane gas orifice in plastic parts bag for future use,
and keep with package containing literature.
6. Replace the broil burner in the hole in the oven back with the
broil burner assembly inside the broil burner electrode hole
as illustrated.
A. Broil burner orifice hole
B. Broil burner electrode
C. Broil burner electrode hole
7. Reinstall the oven broil burner screw. See Step 1 for
illustration. The screw is aligned with the hole when
a click sounds.
A
B
Broil burner hanging
in back of oven
C
A B
Convert Oven Bake Burner (left oven cavity on 48"
[121.9 cm] models)
1. Remove oven racks. See the "Remove Racks" section.
2. Remove the oven door. See the "Remove Oven Door"
section.
3. Slide the bake burner cover to the right or left.
A
4. Lift up and remove oven bake burner cover, and set aside.
5. Remove the oven bake burner screws and oven bake burner,
and gently set aside.
D
C
A. Oven bake burner
B. Oven bake burner screws
C. Oven bake burner electrode bracket
D. Oven bake burner electrode
C
A. Bake burner cover
A
A
B
33