Jennair Rise JGRP648HL Instructions D'installation page 22

6. Pull electrode out of bracket.
A
B
A. Grasp electrode here.
B. Bracket
7. Apply masking tape to the end of a 1/4" (6.4 mm) nut driver
to help hold the gas orifice spud in the nut driver while
changing it. Insert nut driver into the gas opening, and press
down onto the gas orifice spud, then remove by turning the
gas orifice spud counterclockwise and lifting out. Set gas
orifice spud aside.
A
A. Gas orifice spud
8. Gas orifice studs are stamped with a letter and a number.
Install the Number 125 oven bake burner orifice spud.
9. Place Natural gas orifice in plastic parts bag for future use,
and keep with package containing literature.
22
10. Push down on the clip on the electrode bracket.
A. Oven bake burner electrode bracket
B. Electrode bracket clip
11. Replace oven bake burner electrode inside bracket.
B
A
A. Oven bake burner electrode
B. Oven bake burner electrode bracket
12. Reinstall the oven bake burner and oven bake burner
screws. See Step 4 for illustration.
13. Replace oven baffle and oven baffle nuts. The front holes will
be aligned, and a click will sound when baffle is seated.
B
A