Installation Instructions; Unpack The Range - Jennair Rise JGRP648HL Instructions D'installation

WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
Remove shipping materials, tape, and film from range.
Keep shipping pallet under range. Remove oven racks, and parts
package from inside oven. Remove grates from top of oven.
Remove Kick Plate
1. Your range will have the kick plate packaged on top of the
unit.
a. Remove kick plate from top of range and grate pack.
In packaging
A. Kick plate
Packaging removed
A. Kick plate
b. Lay kick plate to the side to avoid scratching.
10

INSTALLATION INSTRUCTIONS

Unpack the Range

A
A
2. For 48" (121.9 cm) models only, rotate center support
counterclockwise off the pallet until it stops.
NOTE: This support is used only for shipping and is not
needed for installation.
3. Lay a piece of cardboard from side packaging on the floor
behind range. Using two or more people, firmly grasp
each side of range. Lift range up about 3" (8.0 cm) and
move it back until range is off shipping pallet. Set range on
cardboard to avoid damaging floor.