Jennair Rise JGRP648HL Instructions D'installation page 31

4. Remove the oven bake burner screws and oven bake burner.
Rotate burner 90° to the left, and gently lay on its side.
A
A. Oven bake burner screws
B. Oven bake burner
C. Oven bake burner electrode bracket
D. Oven bake burner electrode
5. Lift up clip on the oven bake burner electrode bracket with a
finger or flat-blade screwdriver, and pull away the electrode.
A. Oven bake burner electrode bracket
B. Electrode bracket clip
D C
B
B
A
6. Pull electrode out of bracket.
A
B
A. Grasp electrode here.
B. Bracket
7. Apply masking tape to the end of a 1/4" (6.4 mm) nut driver
to help hold the gas orifice spud in the nut driver while
changing it. Insert nut driver into the gas opening, and press
down onto the gas orifice spud, then remove by turning the
gas orifice spud counterclockwise and lifting out. Set gas
orifice spud aside.
A
A. Gas orifice spud
8. Gas orifice studs are stamped with a letter and a number.
Install the Number 189 oven bake burner orifice spud.
9. Place Propane gas orifice in plastic parts bag for future use,
and keep with package containing literature.
31