Jennair Rise JGRP648HL Instructions D'installation page 20

To Convert IR Grill Burner for Propane
1. Unplug range or disconnect power.
2. Remove grill knob and bezel. The other surface knobs and
bezels should still be off the range.
3. Open the oven door and remove the two screws on each
side of the range that hold the control console in place.
NOTE: Make sure to leave oven door open or the control
console will not rest in the side brackets properly once it is
detached.
4. Pull up on the control console and let it drop forward into the
notched console brackets on each side.
A
A. Control console bracket
5. Remove the two screws holding the grill orifice holder
bracket.
B
A. Screws
B. Grill orifice holder bracket
20
6. Pull the grill orifice holder out of the burner box far enough
away to allow access to the orifice with a wrench, using
caution not to kink the attached tubing.
7. Using an adjustable wrench and a 1/2" (1.3 cm) open end
wrench remove the Natural (NG) gas orifice spud and replace
with the correct Propane (L) orifice spud.
8. Reposition the grill orifice holder assembly back into the
burner box, and replace the grill orifice holder bracket and
two holder screws.
9. Lift up on the control console and set it back into place. For
a proper fit, the flange of the control console must hook over
the lip on the front of the range cooktop.
NOTE: It may be necessary to lift valve stems to align with
console holes.
A
A
B
A. Grill orifice
B. Grill orifice holder
Hold with adjustable
wrench here
A
B
A. Control console flange
B. Front lip of range cooktop
Use 1/2" (1.3 cm)
open end wrench
to remove/replace
orifice