Setting The Fineness Of The Coffee Mill; Cup Warming; Preparation - Rotel Universa 785 Mode D'emploi

2.5 Setting the fineness of the coffee mill

Please note: The fineness setting may only be adjusted when the coffee mill is in
operation.
You can adjust the grinder to suit the roast of your coffee beans. We would recom-
mend, however, that you leave the coffee mill at the medium setting.
• Open the cover (12) of the brewing unit.
• Turn the adjustment knob (20) to the desired position with the mill running (Fig. F).
The smaller the dots, the finer the coffee is ground. The following thereby applies:
– Lightly roasted beans require a fine setting.
– Dark roasted beans require a coarse setting.

2.6 Cup warming

This appliance is fitted with a separately switched, active cup warming function. If you
switch the heating on, the cups on the cup shelf (11) will be pre-warmed. Make use of
this to optimise the temperature and the flavour of your coffee:
• The cup heater is switched on or off by pressing the button (10). The Main power
switch (7) must also be switched on.
• The display briefly indicates «Cup heater on» or «Cup heater off».

3. Preparation

Please note:
☛ The coffee machine has been set up at the factory so that you can immedi-
ately make your first cup of coffee. We would recommend, however, that you
program the most important basic settings according to your requirements.
You should therefore first carry out the steps explained in Chapter 4
Programming for setting the language, filter and water hardness (if you have
not already done this during the first operational start up. Chapter 2.3).
☛ When using the coffee machine for the first time, or if the appliance has not
been used for a long time, the first cup of coffee will not have a full flavour and
should not be drunk.
☛ The appliance is fitted with automatic cup lighting for even more visual pleas-
ure. This lights up while the coffee is being prepared, and goes out a few
seconds after the coffee-making cycle is completed.
Please note: When you make a coffee for the first time, the mill chamber is still empty.
It can happen that the «Fill up beans» display appears after the first grinding action
and the appliance will not make any coffee. In this case, simply press the Control but-
ton (2) again and the procedure will be repeated.
43