Makita RT0700C Manuel D'instructions page 8

distance between the bit and the trimmer guide by
turning the adjusting screw (1 mm (3/64") per turn). At
the desired distance, tighten the clamp screw (B) to
secure the trimmer guide in place.
1
2
3
4
011845
When cutting, move the tool with the guide roller riding
the side of the workpiece.
1
001998
Tilt base (optional accessory)
Tilt base (optional accessory) is convenient for
chamfering.
Place the tool onto the tilt base and close the locking
lever at the desired protrusion of the bit. For desired
angle, tighten the clamping screws on its sides.
011993
Firmly clamp a straight board to the workpiece and use it
as a guide against the tilt base. Feed the tool in the
direction of the arrow.
Base protector removed from the tilt base (optional
accessory)
Mounting the base protector which has been removed
from the tilt base on the trimmer base allows the change
of the trimmer base from the round base to a square
base.
For another application, remove the base protector from
the tilt base by loosening and removing four screws.
1. Clamp screw (A)
2. Adjusting screw
3. Clamp screw (B)
4. Trimmer guide
1. Workpiece
2
2. Bit
3. Guide roller
3
1. Clamping
1 screws
2
011994
And then mount the base protector on the trimmer base.
Offset base (optional accessory)
012085
(1) Offset base (optional accessory) is convenient
for work in a tight area such as a corner.
3
1
011858
Before installing the tool on the offset base, remove the
collet nut and collet cone by loosening the collet nut.
1
2
011985
8
1. Base protector
1 2. Screw
1. Pulley
2. Collet nut
3. Collet cone
2
1. Wrench
2. Pulley
3. Shaft lock
3