Makita RT0700C Manuel D'instructions page 13

For the plunge base
1
1. Dust nozzle
2. Thumb screw
011853
Use the dust nozzle for dust extraction. Install the dust
nozzle on the tool base using the thumb screw so that
protrusion on the dust nozzle fit to the notch in the tool
base.
Then connect a vacuum cleaner to the dust nozzle.
011854
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before
inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
2
attempting to perform
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
2
011846
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Straight & groove forming bits
•
Edge forming bits
•
Laminate trimming bits
•
Straight guide assembly
•
Trimmer guide assembly
•
Trimmer base assembly
•
Tilt base assembly
•
Plunge base assembly
•
Offset base assembly
•
13
1. Limit mark
1
1. Screwdriver
2. Brush holder
cap
1
or attachments
Only use accessory or
are