EINHELL SMARAGD Instructions De Montage page 5

Page 19
Important note:
Make sure that the narrow side of the spacers is
attached to the floor profile. The wider side is used
to fix the plastic web panel.
Page 20
26
Assembly of the plastic web panels on the
sides
Important note:
The outside of the plastic web panels (with UV
coating) is marked „Außenseite / Outside" at the
edge, and it is also the side onto which the protective
film has been stuck.
Only remove the protective film from the plastic web
panel you are currently installing.
Page 21
Top illustration: Assembly preview / reference
diagram (side) (illustration shows a 5-panel
greenhouse)
Page 22
Figure 26/d: Profile diagram (double clip / side strut)
Tip: Use a solid object (e.g. the handle of a
screwdriver) to lightly tap several times on the clips
and knock them from the top down into position.
Page 23
Figure 26/e: Profile diagram (single clip / corner
profile)
Important note:
Make sure that the narrow side of the spacers is
attached to the floor profile. The wider side is used
to fix the plastic web panel.
Page 24
27
Assembly of the plastic web panels on the
window rabbet profile
Important note:
The outside of the plastic web panels (with UV
coating) is marked „Außenseite / Outside" at the
edge, and it is also the side onto which the
protective film has been stuck.
Only remove the protective film from the plastic web
panel you are currently installing.
Page 25
27/d: Loosen the screws on the window rabbet profile
and slide the window rabbet profile far enough down
until the plastic web panel is fully enclosed (refer to
the profile diagram 27/d). Then retighten the nuts.
ABA_SM_Teil2_Titel+GB.pmd 5
Page 26
28
Assembly of the plastic web panels
on the roof
Important note:
The outside of the plastic web panels (with UV
coating) is marked „Außenseite / Outside" at the
edge, and it is also the side onto which the protective
film has been stuck.Only remove the protective film
from the plastic web panel you are currently installing.
Page 27
Top illustration: Assembly preview / reference
diagram (roof) (illustration shows a 5-panel
greenhouse)
Page 28
Please note (Figure 28/c):
Always use a safety stepladder when installing the
clips on the roof, and also take great care to ensure
that the stepladder has a secure footing.
Tip:
Use a solid object (e.g. the handle of a screwdriver)
to lightly tap several times on the clips and knock
them from the top down into position.
Figure 28/d: Profile diagram (double clip / side strut)
Figure 28/e: Profile diagram (single clip / corner
profile)
Page 29
29
Assembly of the rubber profile on the
window rabbet profile
29/a + 29/b: Cut a length of approximately 73 cm of
window sealing profile and pull it into the guide rail of
the window rabbet profile (refer to the profile dia-
gram). Make sure that the rubber protrudes slightly
above the two clips on the roof struts.
Page 30
30
Pre-assembly of the double door
Right-hand door wing
Important note:
The outside of the plastic web panels (with UV
coating) is marked „Außenseite / Outside" at the
edge, and it is also the side onto which the protective
film has been stuck.
Only remove the protective film from the plastic web
panel you are currently installing.
Important note – take care not to mix up the
components:
There is only a minimal difference in terms of size
between the plastic web panels 85.043.19 and
85.043.04. Make sure that you fit the shorter plastic
07.04.2006, 10:39
5