Accessories - Husqvarna T435 Manuel D'utilisation

Saw chain speed at 133% of maximum engine power
speed, m/s.
Recommended cutting equipment
Chainsaw model Husqvarna T435 have been evaluated
for safety according to EN ISO 11681-2:2011/A1:2017
(Machinery for forestry - Portable chainsaws - Safety
requirements and testing. Part 2: Chainsaws for tree
service) and fulfill the safety requirements when
equipped with the below listed guide bar and saw chain
combinations.
Kickback and guide bar nose radius
Guide bar
Length, in/cm Pitch, in
12/30 3/8
14/36
16/41
12/30 3/8
14/36
16/41
The usable cutting length is usually 1 in less than the
nominal guide bar length.
Filing equipment and filing angles
Use a Husqvarna file gauge to sharpen the saw chain. A
Husqvarna file gauge makes sure that you get the
H36 5/32 in / 4.0 mm
H37 5/32 in / 4.0 mm
30

Accessories

Gauge, Max. nose ra-
in/mm dius
0.050/1.3 7T
0.050/1.3 7T
505 24 37-01
579 65 36-01
Husqvarna T435
25.3
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012.
Saw chain
Type
Husqvarna
H37
Husqvarna
H36
correct filing angles. The part numbers are given in the
table below.
If you are not sure how to identify the type of saw chain
on your product, refer to www.husqvarna.com for more
information.
0.025 in / 0.65
mm
0.025 in / 0.65
mm
Length, drive Low kickback
links (no.)
45 Yes
52
56
45
52
56
30° 80°
30° 80°
733 - 002 -