Sony ExwaveHAD DXC-390 Mode D'emploi page 25

LINEAR MATRIX
Processes an image with a color matrix to change the chroma
saturation and hue in order to reproduce natural color.
Selection Function
ON Corrects the color to reproduce natural color.
OFF Color correction does not function. Use when you want to
process the image.
When you set LINEAR MATRIX to ON, MODE is displayed.
You can adjust the color suitable for an object.
When you set MODE to MANUAL, R. PAINT, G. PAINT
and B. PAINT appear.
Selection Function
STANDARD Normally, select this setting.
R ENHANCE Enhances the red.
B ENHANCE Enhances the blue.
G ENHANCE Enhances the green.
MANUAL Adjusts each color finely.
R. PAINT: Finely adjusts the red in the range from –30 to
+30.
G. PAINT: Finely adjusts the green in the range from
–30 to +30.
B. PAINT: Finely adjusts the blue in the range from
–30 to +30.
TARGET COLOR
Select when adjusting DETAIL or LINEAR MATRIX for a
specific color.
Selection Function
ALL Adjusts DETAIL or LINEAR MATRIX for the whole image.
Normally, set to this position.
IN Adjusts DETAIL or LINEAR MATRIX for a specific color.
With the RANGE setting you can finely adjust the area in
the range from –10 to +10.
OUT Adjusts DETAIL or LINEAR MATRIX for colors other than a
specified one.
With the RANGE setting you can finely adjust the area in
the range from –10 to +10.
How to specify a color
1
Select IN or OUT and press the ENTER button.
2
Move the cross cursor ( ) appearing in the center of the
screen to the desired color with the
so that the cross cursor square covers the desired color,
then press the ENTER button.
When you select IN, you can adjust the color indicated
by the cross cursor ( ).
When you select OUT, you can adjust colors other than
that with the cross cursor.
   
, , or button
25
Chapter 2 Operation (GB)