Sony UPX-DP10 Mode D'emploi page 84

Appendixes
Printer
Symptom Possible causes/Action
• Check that the printer's power
Power does not go on.
cord is plugged in properly.
t Properly connect the power
• Check that the ink ribbon
Printer does not print
cartridge and printing paper are
properly loaded.
t Properly load the ink ribbon
• Check that the ink ribbon
cartridge cover is closed.
t Close the ink ribbon cartridge
• Check that the bottom cover is
closed.
t Close the bottom cover.
• The printer may have
overheated.
t Wait for a while, then try
• Operation of the printer may
Cannot remove the ink
have been prematurely
ribbon cartridge
interrupted, leaving the teeth of
the ink ribbon cartridge gear
engaged.
t Turn the printer's POWER
• Check whether you have loaded
Paper jams
more than 25 sheets of paper in
the paper supply/eject tray.
t Load no more than 25 sheets
• Check whether more than 10
sheets of paper have
accumulated on the eject surface
of the paper supply/eject tray.
t Do not allow more than 10
• Check whether the paper is
wrinkled or curled.
t Remove any wrinkled or curled
• Check whether paper has
The ERROR lamp is lit
jammed.
t Clear the jam as explained in
84
cord as explained in "Power
Connections" (page 36).
cartridge and printing paper as
explained in "Preparation of
the Printer" (page 29).
cover.
printing again.
switch back on, then remove
the ink ribbon cartridge after
the sound of operation stops.
of paper in the paper supply/
eject tray at a time.
sheets of paper to accumulate
on the eject surface.
paper.
"If the paper jams"
(page 86).
Symptom Possible causes/Action
The printed result does
• Check whether you are printing
not look clean.
on the right side of the paper.
t Properly load the printing
• Check whether the ink ribbon
cartridge or printing paper are
dirty.
t Load a new ink ribbon
paper as explained in "Loading
the printing paper" (page 32)
cartridge or clean printing
paper.