Rehau rautool G1/H/G1 Mode D'emploi page 31

5. Insert joint fully into clamp ing tool.
Caution:
Do not tilt. Tool must be applied over full surface and at right angles.
6. Insert the compression sleeve all the way up to the fitting collar by
activating the pressure switch / foot lever.
Processing at temperatures of under -10°C and over 45°C may result
in damage to the joint components, the tool and/or in personal injury
- Do not work below the minimum processing temperature of -10°C
- At low temperatures (below 0°C), it is recommended that the
joint components be stored in a warm environment before
processing
Please observe also the instruction leaflet of the compression
sleeves 110x10!
31