Safety Warnings - Rehau rautool G1/H/G1 Mode D'emploi

rautool G1/H/G1

saFety warninGs

Intended use
The tool is intended to be used only with original REHAU sup-
plementary sets for machining the REHAU compression sleeve
system in the size range of 40 – 110 mm
Read all safety warnings and assembly instructions before
using the tool Follow these operating instructions and always
keep the safety warnings with the tool
In addition to the operating instructions, always observe
generally applicable statutory and other binding regulations
relating to the prevention of and protection against accidents
General safety warnings:
1. Keep your workplace tidy and free of obstructions. Make sure there
is always sufficient light.
2. Keep children, pets and unauthorised persons away from the place
at which you are working. Do not let any other persons touch the
hydraulic hose, tool or cable.
3. Wear suitable working clothing. Do not wear loosely fitting clothes
or jewellery. They may get caught in moving parts. Wear a hairnet
if you have long hair. Use goggles.
4. Do not touch moving parts (risk of trapping fingers).
5. Be alert. Only use the tool if you have received instructions in using
it.
6. Keep your tools in a safe place. When not in use, tools should be
kept in dry, closed rooms out of the reach of children.
only
7. The tool is to be used to create REHAU compression sleeve
joints with the dimensions 40-110
electro-hydraulic unit for other purposes or dimensions.
8. Only operate the tool with original REHAU parts and accessories.
9. Only have servicing and repair work done at a specialist work shop
authorised by REHAU.
mm. Do not use the tool or the
We reject any liability for work perfomed by non-authorised person-
nel. The addresses of authorised service centers may be obtained
from your dealer or REHAU sales office.
Tool-specific safety warnings:
(electro-hydraulic unit/foot pump)
1. Keep the tool dry and protect it from extreme heat, oil and solvents.
2. Do not carry the hydraulic unit by the supply cable or hydraulic
hose. Do not pull the tool along behind you by the supply cable or
hydraulic hose.
3. Be sure not to damage the hydraulic hose or the power supply cable.
Before use, al ways check the hydraulic hose and power supply
cable, e.g. for chafing, cuts, cracks, bruising, kinks etc. Never
work with a damaged hydraulic hose or supply cable. Immediately
instruct the REHAU Service Center to replace damaged hydraulic
hoses or power supply cable.
4. Do not touch any points of leakage on hydraulic hoses while the
system is under pressure.
5. Do not attempt to uncouple the quick couplings when the system
is pressurised.
6. The quick coupling must not be pressurised when uncoupled.
7. For safety reasons (legal regulations) the hydraulic hose must be
replaced after at most five years by an authorised REHAU Service
Center. This time period must not be exceeded. The year of
construction of the tool can be found on the guarantee card. If
anything should be unclear, please contact your dealer or a
REHAU sales office.
8. Do not connect the pump/power unit up to any other cylinders or
tools.
23