Rehau rautool G1/H/G1 Mode D'emploi page 24

Electro-hydraulic unit:
1. Only use single-phase alternating current of the stated voltage
(see power specification label).
2. Do not subject the unit to rain. Do not operate the unit in an
environment that is damp, wet and/or at risk of fire or explosion.
3. Never leave the device unattended when connected up to a power
supply.
4. Be careful to utilise suitable extension cables.
5. Remove from the power supply when carrying out every tool
modification (e.g. replacing the expander heads, jaw sets) so that
unintentional activation can be avoided.
6. To prevent the motor from over heating, do not operate at
maximum pressure for any prolonged period.
Processing work carried out at temperatures under -10°C and
over 45°C can damage the joint components and the tool, and
can bring about personal injury
- Do not go below the minimum processing temperature
of -10 °C
- At low temperature (below 0 °C) it is recommended that
the joint components be stored in a warm environment
beforehand
24
REHAU will not accept any liability for damage or injury attri-
butable to unsafe product use, poor maintenance or improper
product or system usage
For planning and assembly kindly use our current Technical
Information brochure You can obtain the up-to-date brochure
from your wholesale dealer, your REHAU sales office or by
downloading from www rehau com