EdilKamin IDROPELLBOX 15,7 Installation, Usage Et Maintenance page 34

Mimic panel
to turn on and o
to access the menu during programming
to increase the various settings
to decrease the various settings
pellet loading/reserve utton
press once to in orm' the oiler- replace memor that a 15 g sac o pellets has een loaded, there
eep trac o the reserve.
oiler setting utton
Controls a secondar circuit, e.g. that o a oiler. The right side o the displa sho s the temperature o an e ternal
storage tan / oiler i the oiler sensor is connected . ress the
is not connected, dashes ill appear instead o the temperature --- °C .
e t displa
Filling the feed screw
the pellet storage tan is completel emptied, it ollo s
that the Archimedes' scre is also emptied. e ore restarting
the stove ou must ll it
+/- e s simultaneousl via the remote control or the s noptic
panel or a e seconds, a ter hich, having released the e s,
the displa ill sho the te t " eload .
t is quite normal or some pellet residue to remain inside the
hopper, this is hat the eed scre is una le to pic up. nce a
month, ull vacuum the hopper to prevent dust residue rom
accumulating.
Automatic ignition
ith the oiler- replace on stand- , press the 0/1 utton or
2 seconds on the s noptic panel or remote control . This ill
start-up the ignition process,
and a countdo n ill commence in seconds 1020 . There
is no preset time or the ignition process its duration ill e
automaticall shortened i the control oard detects that certain
tests have een carried out positivel .
The ame appears a ter a out 5 minutes.
Manual ignition (in case of start up failure)
At a temperature lo er than 3 °C too lo
resistance to ecome red hot - or i the resistance is tempora-
ril not or ing, ou can use a relighter to ignite the oiler-
replace.
INSTRUCTIONS FOR USE
hold do n or 2 and to e it rom the menu during programming
ellet load/reserve
emote control receiver
ollo ing these steps press the
tart' ill appear on the displa
or the electrical
oiler' utton to see the set value.
oiler
nsert a ell-lit relighter into the com ustion cham er, close
the door and press 0/1 on the s noptic panel or remote control.
Operating modes
perating rom s noptic panel/remote control.
ith the oiler- replace running or on stand- , rom the
s noptic panel.
ress the + or e s to increase or decrease the desired ater
temperature.
t is possi le to visualise i the oiler pro e is connected the
temperature o an oiler/e ternal storage,
" oiler e the set value is displa ed,
hile vie ing the oiler value set that setting can e varied.
the oiler pro e is not connected dashes appear in place o the
temperature --.-° C .
- 34
-
allo ing it to
the oiler sensor
ight displa
pressing the
pressing the +/- e s