VOLTCRAFT CHARGE MANAGER 2015 Notice D'emploi page 33

Overview display:
1:CHA >
?
MICRO
00:23
Here a display of all inserted batteries with the respective programme and the charging progress (battery
symbol) is displayed. If the charging status of the battery was not yet established, a question mark („?")
appears. If the battery is being processed, the battery symbol or an arrow are displayed alternatingly: if
charging is in process, the arrow points upwards and if the battery is being discharged it points down-
wards.
Battery data display:
1:CHA >
?
MICRO
00:23
The charge programme (e.g. CHA for CHARGE) and charge capacity (C) are displayed in the first line.
In the 2nd line the battery symbol (?) displays the approximate charge status of the battery and the
discharge capacity (D) is displayed.
If charging is in progress, an arrow flashes in front of „C" and if discharging is in progress, an arrow flashes
in front of „D".
In the third line the battery type and the measured battery voltage are displayed. For Mono and Baby
cells, „MONO" and „BABY" is displayed alternatingly, for Mignon batteries, „MIGN" and for Micro batte-
ries, „MICRO" is displayed.
The fourth and last line displays the processing time in hh:mm which has already been passed. The
charge and discharge current is also displayed.
ATTENTION
Immediately remove the battery if the battery type (MONO/BABY, MIGNON or MICRO) is not dis-
played correctly. Ensure proper fit, when inserting the battery.
If a voltage has not been ascertained yet, the following display appears
1:CHA >
?
MICRO
00:00
A running programme can only be interrupted by removing the battery. If the battery is removed during
the charging or discharging process, it is possible that the message ERR (error) or RDY (ready) briefly
appears, because the device detects that power is not supplied any longer.
C=123.1mAh
D= 0.0mAh
U= 1.210V
I= 0.319A
C=123.1mAh
D= 0.0mAh
U= 1.210V
I= 0.319A
C= 0.0mAh
D= 0.0mAh
U= -.---V
I= 0.000A
33