VOLTCRAFT CHARGE MANAGER 2015 Notice D'emploi page 31

If no battery is inserted and any key is pressed, the message „Insert battery" is displayed for approx. 2
seconds.
CM2015
====================
INSERT BATTERY
Now insert the battery of the MONO, BABY, MIGNON or MICRO size in one of the 4 slots. Observe the
polarity. the plus pole of the battery must also be directed towards the rear of the charging device and the
minu pole of the battery in the direction of the A-B charging slots.
The charge device identifies this battery and starts querying the programme settings.
CM2015
====================
SET PROGRAM S1<>
- ADJ CHARGE
Now, only the charge programme needs to be selected with the two SELECT keys (UP and DOWN). You
can select between five different programmes.
- ADJ CHARGE
- ADJ DISCHARGE
- ADJ CHECK
- ADJ CYCLE
- ADJ ALIVE
These program have the following tasks:
CHA (CHARGE) means that the inserted battery connected will be charged.
DIS (DISCHARGE) means that the inserted battery will be discharged.
CHK (CHECK) means that the inserted battery will be discharged and recharged.
CYC (CYCLE) means that the inserted battery will be first charged, then discharged and finally recharged.
CHA
DIS
CHK
CYC
ALV
31