Settings And Adjustments - Life & Mobility Canto Nxt Mode D'emploi

Safety instructions
n Lean or push your body in the direction of the top
of the slope. This will shift the centre of gravity of
the wheelchair to a better position and will reduce
the risk of the chair tipping over backwards.
n Do not push the wheelchair up slopes while the
seat is tilted.
n The person pushing the wheelchair must continue
to push the chair to prevent it from starting to
move under its own momentum.
n Do not turn the wheelchair round on a steep slope.
n If the wheelchair is facing across a steep slope, it
can very easily tip over.
n Always keep your speed under control when
going downhill.
n The accompanying person must reduce the speed
of the wheelchair via the push-handles.
n If you are operating the wheelchair yourself, only
slow the wheelchair down by hand, not by using
the brake, as this can cause you to lose control of
the wheelchair.
EN14
B
A
Adjust frame width
G
F
E
C
D
B
A
* In the case of a manual wheelchair,
the wheel size and seat angle
adjustment might be a hindrance.

Settings and adjustments

The Canto Nxt has a wide range of settings
and adjustment possibilities with which the
wheelchair can be adjusted to suit all the
requirements of the user. Life & Mobility
recommends that you consult your dealer
with regard to the settings. You can easily make
adjustments yourself, without the use of tools.
Frame
Frame width
n Remove the 8 socket screws (A).
n Unscrew the 4 socket screws (B) a few turns.
n Adjust the desired seat
symmetrically.
n Tighten all socket screws again.
Seat width
The width of the seat frame is adjustable and
can be set to widths of 37, 42, 47 and 52 cm. It
is also possible to fit the sides, with armrests,
further in or out. This adjustment can be made
separately on the left and on the right. Each
side, with armrest, is continuously adjustable.
It can be moved 3 cm in or out*.
Adjust inwards, or adjust outwards no more
than 2 cm
n Loosen the socket screw (A).
n Reduce the framewidth to the desired size.
n Retighten the socket screw (A).
n Repeat this on the other side.
Adjust 2 cm outwards
n Loosen the star grips (B) and remove the
complete side from the adapter.
n Loosen the socket screws (D) that clamp
the padded section to the side tube (E)
and remove the padded section.
n Unscrew and lift the star grips (F)
completely out of the side tube.
width
EN15