GE PVUS930 Manuel De L'utilisateur page 13

This product can be installed in 2 different ays.
- Mounting the hood in the lower part of the cabinet.
B type installation Fig.9.
- Mounting the hood on the wall:
A type installation Fig.9.
- Chec that the scre s used that are not supplied ith the product are suitable for the type of
object.
- Position the xing template on the lo er part of the shelf Fig.8B), considering the minimum
distance from the coo er top).
- Ma e 6 holes in the shelf respecting the measurements indicated Fig.7).
- Fix the 4 scre s A ithout tightening them completely.
- Position the hood under the pensile, push to ards the all up to end run, tighten/fasten the 4
scre s A and x it de nitively using the 2 safety scre s B.
Position the xing template on the all Fig.8A), considering the minimum distance from the
coo er top).
- Ma e 4 holes respecting the measurement indicated in the gures Fig.7).
- Fix the 2 upper scre s A ithout tightening them completely along ith the plugs.
- Hang the hood on the all, aligning it in a horizontal position and tighten/fasten the 2 scre s
A. When it has been regulated, x it de nitively using the 2 safety scre s B.
For the various installations use scre s and scre anchors suited to the type of all e.g.
reinforced concrete, plasterboard, etc.). If the scre s and scre anchors are provided ith the
product, chec that they are suitable for the type of all on hich the hood is to be xed.
Limited to installation on plasterboard alls: ma e sure that the scre s are xed to the all
support elements. If this is not the case, install a support structure made up from 2 by 4 inch
5.08 by 10.16 cm) cross members in correspondence ith the scre anchorage points.
12