Tools You Will Need - GE PVUS930 Manuel De L'utilisateur

DAMAGE – SHIPMENT/INSTALLATION
If the unit is damaged in shipment, return the unit to the
store in which it was bought for repair or replacement.
Call 800.531.3344.
If the unit is damaged by the customer, repair or
replacement is the responsibility of the customer.
If the unit is damaged by the installer (if other than
the customer), repair or replacement must be made
by arrangement between customer and installer.
MOUNTING SPACE
66" or
more from
the floor to
the top of
the hood
NOTES:
Hood width may be greater than the width of the range
or cooktop, but it may not be smaller.
Ensure the range or cooktop is installed per
manufacturer's installation instructions.
If you are going to vent your range hood to the outside,
see the "Ducting Requirements" section for exhaust duct
preparation.
1 ft = 0.3 m; 1 in. = 2.5 cm
Installation Instructions

TOOLS YOU WILL NEED

Flat-blade and Phillips
Saw (saber or
Bottom edge of
cabinet needs
to be 30" or
more from
1/4" pivoting
the cooking
hex socket
surface
30"
min.
Flashlight
PARTS YOU WILL NEED
6" round straight ducting
6" round 90° elbow ducting
6"-7" hose clamp (2)
9
Pencil
screwdrivers
Electric drill
keyhole)
Tape measure
Pliers
Caulking Level
Duct tape
Metal snips
(in some
applications)
Wire stripper
1/4" Nutdriver