Hood Lights; Stainless Steel Surfaces - GE PVUS930 Manuel De L'utilisateur

Stainless Steel Surfaces (on some models)
Do not use a steel-wool pad; it will scratch the surface.
1. Sha e bottle ell.
2. Place a small amount of CERAMA BRYTE
Conditioner on a dry cloth or dry paper to el.
3. Clean a small area approximately 8 x 8 /20.3 cm x 20.3 cm), rubbing ith the
grain of the stainless steel if applicable.
4. Dry and buff ith a clean, dry paper to el or soft cloth.
5. Repeat as necessary.
To order:
To order CERAMA BRYTE
®
our toll-free number:
National Parts Center
CERAMA BRYTE
®
Stainless Steel Cleaning
Polish and Conditioner

Hood Lights

This hood requires t o bulbs
Purchase and install WB27M02956, 50 W Maximum halogen bulbs.
When replacing a bulb, let it cool rst. Ma e sure that po er to the light has been
turned off. Never allo a hot bulb to come into contact ith ater.
WARNING:
To reduce the ris of electric shoc , do not connect electrical po er
to the hood ithout both bulbs in place.
To change the light bulbs:
See page 4 and Fig.9.
CAUTION:
Do not touch the hood light bulbs hen they are on. They may be
hot enough to cause injury.
The light bulbs operate at extremely high temperatures. If they
shatter, the hot glass could cause personal injury.
Stainless Steel Cleaning Polish and
®
Stainless Steel Cleaning Polish and Conditioner, please call
1.800.661.1616
www.GEAppliances.ca
# PM10X313
, maximum 50 atts.
6