Hood Lights - GE JV936 Mode D'emploi

Be sure electrical power is off and all surfaces are cool before cleaning or servicing any part of the vent hood.
Receptacle
Socket
Bulb
Glass cover

Hood Lights

NOTE: The glass cover should be removed
only when cold. Wearing latex gloves may
offer a better grip.
CAUTION:
Before replacing your
light bulb, disconnect the electrical power to
the hood at the main fuse or circuit breaker
panel.
Be sure to let the light cover and bulb cool
completely.
For your safety, do not touch a hot bulb with
bare hands or a damp cloth.
To remove:
Turn the glass cover counterclockwise until
the glass cover clears the socket.
Using gloves or a dry cloth, remove the
bulb by pulling it straight out.
To replace:
Use a new 12-volt, 20-watt (maximum)
Halogen bulb for a G-4 base.
Using gloves or a dry cloth, remove the
new bulb from its packaging.
NOTE: Do not touch the new halogen bulb
with bare fingers. Touching the bulb with
bare fingers will significantly reduce the life
of the bulb.
Receptacle
Use gloves
or cloth
Push the bulb straight into the receptacle
all the way.
Place the glass cover onto the socket and
turn clockwise until secure.
For improved lighting, clean the glass cover
frequently using a damp cloth. This should
be done when the hood is completely cool.
Reconnect electrical power to the hood.
GEAppliances.com
5