Hood Lights; Stainless Steel Surfaces - GE PVWC924 Manuel De L'utilisateur Et Instructions D'installation

Stainless Steel Surfaces (on some models)
Do not use a steel-wool pad; it will scratch the surface .
1 . Shake bottle well.
2 . Place a small amount of CERAMA BRYTE
Conditioner on a dry cloth or dry paper towel.
3 . Clean a small area (approximately 8" x 8"/20.3 cm x 20.3 cm), rubbing with the
grain of the stainless steel if applicable .
4 . Dry and buff with a clean, dry paper towel or soft cloth.
5 . Repeat as necessary .
To order:
To order CERAMA BRYTE
our toll-free number:
National Parts Center
CERAMA BRYTE
®
Stainless Steel Cleaning
Polish and Conditioner

Hood Lights

This hood requires two bulbs (not included), maximum 50 watts.
Purchase and install WB27M02956, 50 W Maximum halogen bulbs .
When replacing a bulb, let it cool first. Make sure that power to the light has been
turned off. Never allow a hot bulb to come into contact with water.
WARNING:
To reduce the risk of electric shock, do not connect electrical power
to the hood without both bulbs in place.
To change the light bulbs:
See page 4 and Fig . 9 .
CAUTION:
• Do not touch the hood light bulbs when they are on. They may be
hot enough to cause injury .
• The light bulbs operate at extremely high temperatures. If they
shatter, the hot glass could cause personal injury .
®
Stainless Steel Cleaning Polish and Conditioner, please call
®
1.800.661.1616
www.GEAppliances.ca
# PM10X313
Stainless Steel Cleaning Polish and
6