Operation - SilverCrest SDGS 1630 B1 Mode D'emploi Et Consignes De Sécurité

4) Screw the lid tight and turn the water tank
is closed tight enough that no water can escape.
5) Put the water tank

Operation

►
NOTE
►
►
►
1) Loosen the Velcro strap
2) Plug the power cable
appliance by pressing the On/Off switch
(fig. L). The operating light
When the appliance starts producing steam, the operating light
permanently green.
3) Hang your clothing item on the integrated clothes hanger
clothes hanger that you can attach to the clothes hanger mount
integrated clothes hanger
integrated clothes hanger
4) Take hold of the steam head
away from your body.
5) Start at the top of the piece of clothing and move the steam head
slowly (fig. N). Make sure that the steam hose
■ 12 │ GB │ IE
t
back onto the appliance base
J
WARNING – RISK OF INJURY!
Never attempt to steam pieces of clothing while they are being worn.
When using the appliance, make sure to remove all materials that could
o
block the casters
ance on a level, horizontal surface).
Do not use the appliance on very thick rugs or carpets.
Make sure that the steam hose
q
scopic shaft all the way out if you fasten the steam head
2
mount during use. This ensures an unhindered flow of steam through the
steam hose w .
9
t
of the garment steamer from the floor (use the appli-
w
is not kinked during use. Pull the tele-
0
(fig. K) and unroll the power cable
into the mains power socket and switch on the
i
flashes green while the appliance is heating up.
3
. Also use the clips for trousers/dresses
3
to steam trousers or dresses (fig. M).
1
. Make sure you aim the steam openings
around again. Check that the lid
z
(fig. J).
1
onto the
9
fully.
u
on the front of the appliance
i
3 or another
5
1
w is always vertical.
SDGS 1630 B1
lights up
of the
4
in the
down