Graco Turn2Me Manuel D'utilisation page 10

22
Press the webbing adjustment
button﹐ while pulling out the
shoulder harnesses to the
proper length.
23
Unlock the buckle of the
harnesses by pressing the red
button.
24
Fix the buckles on the both
sides of seat to make placing the
child in rear facing mode more
convenient.
25
Use Infant insert is for children's
protection.
We recommend using the full infant
insert while the baby is 0-6 months
or until they outgrow the insert. The
infant insert increases side impact
protection.
Detach the snaps on the head
support to remove the head portion
of the insert.
Remove the head support portion
of the infant insert when the child's
head no longer fits comfortably.
Remove the body portion of the
infant insert when the infant's
shoulders no longer fit comfortably.
Remove the
1
infant insert
cushion by
detaching the
snaps to allow
more space
2
when the
infant does
not fit
comfortably.
The cushion can be used separately
without being attached to the
insert to bolster the infant's back
for more comfort.
16
Place the child into the child restraint
and pass both arms through the
harnesses.
After the child is seated﹐ recheck
whether the shoulder harnesses are
at the proper height.
26
Engage the buckle.
27
Pull down the adjustment
webbing and adjust it to the
proper length to make sure your
child is properly secured.
Make sure the space between the
child and the Shoulder Harness
Straps is about the thickness of one
hand.
22 23 24
If steps are taken when
arriving at your destination whilst
removing the child﹐ then the harness
will be positioned so that it is out of
the way and ready for loading upon
your return to the vehicle.
Using in the
Forward Facing
Mode
(Forward Facing Mode/for Child
between 9-18kg / 9 months -4
years old)
28 35
See images -
Please install the child restraint on
the vehicle seat﹐ and then put the
4 9
-
child in the child restraint.
28
Press the ISOFIX adjuster button
and pull the base back from the
vehicle seat.
29
Press the rotating button to
rotate for easier side loading/
unloading of the child﹐ then
rotate forwards to desired
direction.
30
If a tighter install or increased
cabin space is required﹐ then
press the ISOFIX adjuster button
and push to adjust.
31
The ISOFIX connectors must be
attached and locked onto the
ISOFIX anchor points.
The load leg must be installed
correctly with green indicator.
After the child is placed into the seat﹐
check whether the Shoulder Harness
Straps are at proper height.
32
Press the webbing adjustment
button﹐ while pulling out the
shoulder harnesses to the
proper length.
33
Unlock the buckle of the
harnesses by pressing the red
button.
34
Fix the buckles on the both sides
of seat to make placing the child
in forward facing mode more
convenient.
When installing the child restraint in
the forward facing mode﹐ do not use
the infant insert.
17