Transport And Storage; Inspect The Delivery - Xylem LOWARA ESH ATEX Manuel D'installation, D'utilisation Et Entretien

EU Declaration of Conformity (n. 04)
1. (ATEX) Apparatus model/Product:
(see label on first page)
2. Name and address of the manufacturer:
Xylem Service Italia S.r.l.
Via Vittorio Lombardi 14
36075 Montecchio Maggiore VI
Italy
3. This declaration of conformity is issued
under the sole responsibility of the
manufacturer.
4. Object of the declaration:
pump (see label on first page)
5. The object of the declaration described
above is in conformity with the relevant
Union harmonization legislation:
•
2014/34/EU Directive of 26 February
2014 (equipment intended for use in
potentially explosive atmospheres)
6. References to the relevant harmonized
standards used or references to the other
technical specifications, in relation to
which conformity is declared:
•
EN 1127-1:2011, EN 15198:2007,
EN ISO 80079-36:2016, EN ISO
80079-37:2016.
7. The notified body
(ATEX)
Pump: SGS Baseefa Limited (NB 1180)
performed the EU-type
examination and issued the certificate
Baseefa16ATEX0067X;
8. Additional information:
(ATEX) The following specific conditions
of use apply.
- The equipment must be suitably earthed
prior to operation.
- It is the user's responsibility to ensure
the equipment does not run dry. Any
control system used to achieve this must
comply with the relevant requirements of
EN 80079-37.
- For T4 operation the maximum
temperature of the liquid to be pumped
must not exceed 90°C.
Pump: II2G Ex h IIC T4 Gb -10°C≤
Tamb ≤+55°C
Signed for and on behalf of: Xylem Service Italia
S.r.l.
Montecchio Maggiore, 30.09.2019
Amedeo Valente
(Director of Engineering
and R&D)
rev.00
Lowara is a trademark of Xylem Inc. or one of
its subsidiaries.

2 Transport and Storage

2.1 Inspect the delivery

1. Check the outside of the package for
evident signs of damage.
2. If the product bears visible signs of
damage, notify our distributor within eight
days from the delivery date.
Unpacking the unit
1. Follow applicable step:
– If the unit is packed in a carton,
then remove the staples and open
the carton.
– If the unit is packed in a wooden
crate, then open the cover while
paying attention to the nails and
straps.
2. Remove the securing screws or the straps
from the wooden base.
2.1.1 Inspection of the unit
1. Remove the packaging material from the
product.
Dispose of all packing materials in
accordance with local regulations.
2. Inspect the product to determine if any
parts have been damaged or are missing.
3. If applicable, unfasten the product by
removing any screws, bolts, or straps.
Guidelines for transport
2.2
Precautions
WARNING:
• Observe the accident prevention
regulations in force.
• Risk of crushing. The unit and the
components can be heavy.
Implement proper lifting methods
and always wear steel-capped
boots.
Check the gross weight that is indicated on the
package in order to select proper lifting
equipment.
Installation and securing
The pump or pump unit can be transported only
horizontally. Make sure that the pump or pump
unit is securely fastened during transportation
and cannot roll or fall over.
en - Original instructions
21