EINHELL KH 500/1 Instructions D'origine page 16

10. Troubleshooting
If the equipment is operated properly you should experience no problems with malfunctions or faults.
In the event of any malfunctions or faults, please check the following before you contact your customer
services.
Fault
Equipment does not
work
Anl_KH_500_1_SPK9.indb 16 Anl_KH_500_1_SPK9.indb 16
GB
Possible cause
Power plug is not connected
The topple cut-out has triggered
The thermostat control is set too low
Overheating guard has been triggered
- 16 -
Remedy
Connect the power plug
Place the machine on a level surface
Turn the thermostat control to the
right, to a higher temperature
Please note section 6.3
19.11.2018 11:15:26 19.11.2018 11:15:26
11