Disposal Of The Appliance; Installation - ZANKER ZKE320 Notice D'utilisation

• Do not place wet pan lids on the hotplates and do
not let hot pans to cool on the hotplates. If not con-
densation and rust can form.
• Do not let cookware boil dry to prevent the damage
to cookware and hotplate.
• Do not use the solid hotplate with empty cookware or
without cookware.
• Do not cover any part of the appliance with alumini-
um foil.

Installation

Installation
Warning! Read and follow the instructions
carefully. There is a risk of injury or damage to the
appliance.
• Make sure that the appliance is not damaged be-
cause of transportation. Do not connect a damaged
appliance. If it is necessary, speak to the supplier.
• Installation and connection of the appliance to
the power supply must only be done by qualified
personnel.
• Only use built-in appliances after you assemble the
appliance into correct built-in units and work surfa-
ces that obey the standards.
• Do not change the specifications or modify this prod-
uct. There is a risk of injury or damage to the appli-
ance.
• Fully obey the laws, ordinances, directives and
standards in force in the country where you use the
appliance (safety regulations, recycling regulations,
electrical safety rules etc.).
• Keep the minimum distances to other appliances
and units.
• Install anti-shock protection, for example install the
drawers only with a protective panel directly below
the appliance.
• If the fixing bracket is near to the terminal block, al-
ways make sure the connection cable does not
come in contact with the edge of the bracket.
• Prevent damage of the cut surfaces of the worktop
against moisture with a correct sealant!
• Seal the appliance to the worktop with no space left
with a correct sealant.

Disposal of the appliance

• To prevent the risk of physical injury or damage
– Disconnect the appliance from the power supply.
– Cut off the mains cable where it connects with the
appliance and discard it.
– Speak to your local authorised facilities for dis-
posal of your appliance.
• Prevent damage of the bottom of the appliance from
steam and moisture, e.g. from a dishwasher or oven.
• Do not install the appliance adjacent to doors and
below windows. Hot cookware can be hit off the hob
when you open doors or windows.
• Disconnect the appliance from the electrical sup-
ply, before you do maintenance work or clean-
ing.
Warning! Risk of injury from electrical current.
Carefully obey the instructions for electrical
connections.
• The electrical mains terminal is live.
• Make the electrical mains terminal free of voltage.
• Install correctly to give anti-shock protection.
• Loose and incorrect mains plug and socket connec-
tions can make the terminal become too hot.
• A qualified electrician must install the clamping con-
nections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable and replace
the damaged mains cable with the proper cable type.
Speak to your local Service Centre.
The appliance must have the electrical installation
which lets you disconnect the appliance from the mains
at all poles with a contact opening width of minimum 3
mm. You must have correct isolation devices: line pro-
tecting cut-outs, fuses (screw type fuses removed from
the holder), ground leakage trips and contactors.
The manufacturer is not responsible for any injury
to persons and pets or damage to property caused
by failure to obey these requirements.
11