Service Menu For Lds 45 O - AIT LD 30 BO Notice De Montage

UK | 10 Commissioning

10.2 Service menu for LDS 45 O

LEDs
LED flashing modes:
38
Parameter Set value /
ventilation level
1
Device type
on LDS 2
(Fan1/Fan2)
Number of device 1
pairs/ 2
devices on LDS 3
(Fan1/Fan2) 4
5
Ventilation levels 1
2
Power units 0
(LT) or 1
room air 2
controls 3
(LDS) 4
5
6
LED flashing rapidly
bold = factory setting
Setting /
description
LD 45
LD 30 BO
The type family, which is connected
to the Fan1/Fan2 fan interface, is
selected here.
Notice: Only single-type LD 45 or LD
30 unit combinations are per-
mitted at the fan interface!
1 device pair LD 45 or 1 LD 30
2 device pairs LD 45 or 2 LD 30
3 device pairs LD 45 or 3 LD 30
Odd number, 3 devices LD 45
Odd number, 5 devices LD 45
The number of units connected to the
fan interface (Fan1/Fan2) is selected
here.
Ventilation level "0" possible
Ventilation level "0" blocked
With the ventilation level "0" blocked
setting, the ventilation units cannot
be switched off on this control. The
units then run with at least ventilation
level 1.
Operation without further LT/LDS
Operation with 1 LT or LDS
Operation with 2 LT or LDS
Operation with 3 LT or LDS
Slave no. 1
Slave no. 2
Slave no. 3
Adjuster for adding further room air
controls (LDS) or power units (LTs) to
this room air control. Example: Two
further LDS (LDS #2 and #3)
are connected to LDS #1. Set
value = 2. Set set value 4 on LDS #2
and set value 5 on LDS #3.
Notice: Only single-type LDS com-
binations are permitted!
LED flashing slowly