AIT LD 30 BO Notice De Montage page 23

UK
Mounting instructions for
UK
LD 30 final mounting kit
These mounting instructions contain impor-
tant information about final mounting of the
drawer units and internal covers. Final
mounting is undertaken once the plastering
and paint work is complete.
Please read these instructions carefully. Fol-
low the instructions. Pay particular attention
to the safety instructions.
Before commissioning, also read the en-
closed operating instructions.
Hand the instructions to the owner for
safe-keeping once the installations are com-
plete.
Commissioning software  online
Can be used with LDS 45 K room air control.
Connect at USB port.
Accessory components
For more information about the final mounting
of accessory components  Accessory
component supplement.
Mounting instructions for LD 30 final mounting kit | UK
Table of Contents
1 Scope of delivery ..................................24
2 Specialist installer qualification ..........24
3 Intended use ..........................................24
4 Safety instructions and warnings .......25
5 Requirements of the installation site ..27
6 Technical data .......................................27
7 Connection options ..............................28
7.1
7.2
7.3
8 Application example .............................30
9 Mounting ................................................31
9.1
9.2
9.3
9.4
9.5
9.6
9.7
9.8
10 Commissioning .....................................37
10.1 Service mode - operation ...................37
10.2 Service menu for LDS 45 O
10.3 Service menu for LDS 45 K
APPENDIX
Installation dimensions ................................65
Wiring diagrams...........................................67
Acknowledgements:
© ait-Deutschland GmbH. Translation of the original
German instructions. We cannot be held responsible
for mistakes or printing errors and retain the right
to make technical modifications without giving prior
notice. The brands, brand names and protected trade
marks that are referred to in this document refer to
their owners or their products.
Combinations with LDS 45 K ..............28
Combinations with LDS 45 O .............29
EnOcean combinations (radio) ...........29
Mounting information ..........................31
Unit structure and positioning ............32
Shortening extension duct ..................32
Gluing on sealing bands .....................33
Installing slide-in module with
extension duct ....................................33
230 V electrical connection .................34
Connecting room air controls ..............35
Installing LD 45 HYI humidity sensor
in LDS 45 O or LDS 45 K ..................36
................ 38
................. 40
23