Making Settings - Conrad RW 53 Notice D'emploi

b) Making Settings
The following settings can be made in sequence:
• Setting the display contrast
• Setting the Time Zone
• Selecting 12/24 h mode
• Manually setting the time (if no DCF reception is possible)
• Switching display order between date/month and month/date
• Selecting wind speed unit (km/h, m/s, bft, mph, knots)
• Correcting wind direction
• Selecting rain volume unit (mm, inch)
• Selecting temperature unit (°C, °F)

The setting mode is started by pushing the button "SET" for two seconds.
Briefly pushing the button "SET" takes you to the respective next setting.
Use the button "+" or "MIN/MAX" to change the set value. Keeping the respective button down for some
time will adjust quickly.
The setting mode is terminated by making the last setting. The setting mode is left automatically if no
button is pushed for approx. 30 seconds.
Proceed as follows:
• Keep the button "SET" pushed for 2 seconds until "lcd" flashes at the upper left of the display.
Use the button "+" or "MIN/MAX" to adjust the LC display contrast.
• Briefly push the button "SET"; "ZON" appears in the upper right of the display and the hours of the time zone flash in
the display.
Use the button "+" or "MIN/MAX" to adjust the time zone in the area of +12 to -12 hours.
• Briefly push the button "SET"; "24Hr" or "12Hr" flashes in the upper left of the display.
Use the button "+" or "MIN/MAX" to switch the display 24 h and 12 h mode. In 12h mode, "PM" is displayed to the left
of the time in the second half of the day.
• Briefly push the button "SET"; the hours of the time flash.
Set the hours with the button "+" or "MIN/MAX".

When changing the time (hours/minutes) or date (year/month/day), the radio tower icon for DCF-reception
goes out.
The manual settings for time and date are automatically overwritten when the outdoor sensor has evaluated
the DCF signal and submits it to the weather station! The radio tower icon is then displayed again.
If you want to start a reception attempt for the DCF signal yourself, proceed as described for initial
commissioning (chapter 8 b) and c) or in chapter 10.
• Briefly push the button "SET"; the minutes of the time flash.
Set the minutes with the button "+" or "MIN/MAX".
35