Removing The Sling - arjo MAA2050M Notice D'utilisation

Harnais pour amputé
Masquer les pouces Voir aussi pour MAA2050M:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 47
shorter the limb(s), the more the patient will tilt
spreader bar, make sure that one caregiver holds
on to the DPS while the other caregiver operates
Move the lift/spreader bar closer to the patient's
EN
WARNING
To avoid the patient from falling, make sure
that the sling attachments are attached
securely before and during the lifting
process.

Removing the Sling

In Bed (12 steps)
Apply bed brakes and adjust the height of the bed
Make sure the spreader bar is in a reclined position
WARNING
To avoid injury to the patient, pay close
attention when lowering or adjusting the
spreader bar.
weight of the patient is taken up by the receiving
(See Fig. 17 )
If using an All Day sling, make sure to place the
Fig. 19
Make sure that all clips/loops are attached securely
While lifting the patient, make sure that:
(See Fig. 20 )
rolling is not possible, use an Arjo sliding sheet/
sheet/tube IFU.
(See Fig. 21 )
Log roll the patient to the other side and remove
patient is in a comfortable and secure position in
In Chair/Wheelchair (13 steps)
(See Fig. 22 )
Fig. 20
12
the spreader bar is in a seated position,
one caregiver pays attention the patient's head
and
that the other caregiver holds up the patient's
leg(s)/limb(s) to prevent them from hitting the
(See Fig. 19 )
WARNING
To avoid injury during log roll, make
sure there is another caregiver present
and/or use the side rails on the opposite
side of the bed.
Continue with the steps on the next page.
Fig. 21
IFU
Sliding

Publicité

Table des Matières
loading

Table des Matières