Battery Pack And Charger - Babboe City Mountain Manuel D'utilisation

70

10.2 Battery pack and charger

Symptom Check
Is the power plug firmly
connected?
Is the charging plug firmly
inserted in the battery pack?
Are the residual battery
capacity lamps lit?
Cannot charge.
Are the battery charger or
battery pack contact
terminals dirty or wet?
Four battery capacity
lamps are flashing
simultaneously.
This is not a malfunction.
There is a contact fault in the
contact terminals.
Action
Reconnect and try charging again. If the
battery pack still does not charge, the battery
charger might be malfunctioning.
Review charging method and try charging again.
If the battery pack still does not charge,
the battery charger might be malfunctioning.
Remove the battery pack from the battery
charger and the charger plug from the socket.
Use a dry cloth or cotton swab to clean the
charger and battery contact terminals, and then
reconnect.
Charging is preparing to charge. Wait a few
minutes. After a while, the battery capacity
indicator lamps will change from simultaneous
four-lamp flashing to steady illumination as
charging begins.
Remove the battery pack from the bicycle,
connect the charging plug into the battery
pack. If lamps still flash alternately, there
might be a fault in the battery pack.
Remount the battery pack on the bicycle
and press the power switch of display unit,
if lamps still flash alternately, there might
be a fault in the drive unit.
71