Pre-Operation Check; Cleaning And Storage; Caring For The Battery Pack - Babboe City Mountain Manuel D'utilisation

7.2 Display of the battery capacity indicator lamps and the estimate of the residual battery capacity
When checking the residual battery capacity, push the battery capacity indicator button:
Display of the battery capacity
indicator lamps
The bottom of lamp slow flashing
The bottom of lamp flashing
Ñ 0,2 second interval Ò
66
Estimate of the residual
Applicable situation
battery capacity
100 - 76%
75 - 51%
From full charge (100%), the battery
capacity indicator lamps turn off, one
by one.
50 - 26%
25 - 11%
10 - 1%
There is very little battery capacity left.
The battery capacity has reached
0%
0 (zero). Please charge the battery pack.

8. PRE-OPERATION CHECK

Be sure to perform the inspection before riding the bicycle. If there is anything you do not
understand or find difficult, please consult a bicycle dealer.
NOTICE
• If you confirm there is a fault, have your bicycle inspected at a dealer as soon as possible.
• The power assist mechanism consists of precision parts. Do not disassemble it.
In aanvulling op de inspecties voorafgaand aan elk gebruik is het raadzaam om ook de volgende inspecties uit te voeren.
Nr. Inspection items Details
1 Residual battery capacity Is enough capacity left in the battery?
Installation status of the
2 Is it properly installed?
battery pack
3 Operation of the e-bike systems Do the e-bike systems operate when you begin moving?
4 Display unit Is the display mounted correctly?

9. CLEANING AND STORAGE

NOTICE
Do not use high-pressure washers or steam jet cleaners since they can cause water seepage, resulting in property
damage or malfunction of the drive unit or battery pack. Should water get inside one of these units, have an
authorized dealer inspect your bicycle.

9.1 Caring for the battery pack

Use a moist, tightly wrung out towel to wipe off dirt on the battery case. Do not pour water directly on the battery
pack, such as with a hose.
NOTICE
Do not clean the charge contacts by polishing them with a file or using a wire, etc.Doing so could result in a fault.
9.2 Storage
Store the system in a place that is:
• flat and stable
• well-ventilated and free from moisture
• sheltered from the elements and from direct sunlight
67