Controls And Displays; Front Panel - Pioneer VSX-C502 Mode D'emploi

04

Controls and displays

Chapter 4
Controls and displays

Front panel

1 2
PHONES/SETUP MIC
VSX-C502
1 PHONES/SETUP MIC jack
Use to connect the headphones or supplied microphone.
When headphones are connected there is no sound
output from the speakers.
2 STANDBY/ON button
Press to switch the receiver on or into standby.
3 FRONT INPUT jacks (page 15)
Use to connect an audio/video component.
4 AV DIRECT indicator
Lights in standby when the receiver is passing an audio/
video signal from one SCART AV connector to another.
5 Digital surround format indicators
2 DIGITAL indicator
Lights when the current source is Dolby Digital.
DTS indicator
Lights when the current source is DTS.
6 Listening mode indicators
2 PRO LOGIC II indicator (page 27)
Lights when one of the Dolby Pro Logic II surround
modes is active with a 2 channel (stereo) source.
2 PRO LOGIC IIx indicator (page 27)
Lights when one of the Dolby Pro Logic IIx surround
modes is active.
NEO:6 indicator (page 27)
Lights when the Neo:6 listening mode is active with a
2 channel (stereo) source.
ADVANCED indicator (page 28)
Lights when one of the Advanced Surround modes is
active.
PHONES indicator (page 28)
Lights when phones surround mode is active.
20
En
3 4
2
AV DIRECT DIGITAL
STANDBY/ON
FRONT INPUT
DIGITAL IN VIDEO L AUDIO R
5 6
2 2
DTS PRO LOGICII PRO LOGICIIx NEO:6 ADVANCED PHONES
7 Remote control sensor
8 INPUT SELECTOR knob (page 26)
Turn to cycle through the various inputs. The current
input is shown in the front panel display.
9 MASTER VOLUME knob
Use to adjust the volume.
7 8
MASTER
INPUT SELECTOR
VOLUME
DOWN UP
9