Using Other Functions; Selecting The Input Signal Type; Using The Sleep Timer - Pioneer VSX-C502 Mode D'emploi

08

Using other functions

Chapter 8
Using other functions

Selecting the input signal type

The DVD, STB, DVR/TV and FRONT inputs all have both
analog and digital jacks. You can select the type of signal
to be used in each case. The DVD input has a third
option; multichannel analog input.
The input signal type for the current input is indicated in
the display: ANA (analog), DIG (digital), and DVD 5.1ch
(multichannel analog).
The default AUTO setting is usually sufficient, letting the
receiver decide the most suitable signal type. However, if
you want to record from the VIDEO IN/OUT AV
connector or the DVR/TV IN/OUT AV connector, then
you should set the input signal type to analog.
1 Press RECEIVER.
2 Press SIGNAL SEL to change the input signal type.
• SEL. AUTO – (default setting) Uses digital if available,
otherwise analog.
• SEL. ANA – Uses the analog signal
• SEL. DIG – Uses the digital signal
• SEL. 5.1ch – Uses the multichannel analog signal
(only selectable for the DVD input)
Note
• When the VIDEO or FM/AM inputs are used, the
display always shows ANA (analog).
• When DVD 5.1ch (multichannel analog) is selected,
only the volume and channel level settings are
applied to the sound; you cannot use the Stereo,
Surround, Advanced Surround modes, Sound Modes
and dialog enhancement. (If you want to use these,
select DIG (digital) as the input signal type.
34
En
RECEIVER
SIGNAL SEL BAND
• MCACC setup is not usable when DVD 5.1ch is
selected. Switch to one of the other settings if you
want to use MCACC setup.

Using the sleep timer

The sleep timer automatically puts the receiver into
standby after the specified period of time.
RECEIVER
1 Press RECEIVER.
2 Press SLEEP to set the sleep timer.
Press repeatedly to select between:
• 90 MIN. – Switches to standby after 90 minutes
• 60 MIN. – Switches to standby after one hour
• 30 MIN. – Switches to standby after 30 minutes
The sleep timer indicator (
has been set.
Note
• The sleep timer is cancelled if you switch on the AV
Direct function. See alsoThe AV Direct mode on
page 10 and AV Direct setting on page 38.
Tip
• Press the SLEEP button once to view how much time
is left on the timer before shutdown. Each press after
that will cycle through the possible sleep time
lengths.
SLEEP
) lights when the sleep timer