Pioneer VSX-C502 Mode D'emploi page 38

09 The System Setup menu
Dual mono setting
Specifies how dual mono encoded Dolby Digital or DTS
soundtracks should be played:
• ch1 – Only channel 1 is played
• ch2 – Only channel 2 is played
• L. c1 R. c2 – Both channels are played through the
front speakers
Note
• On the ch1 and ch2 settings the sound comes only
from the center speaker (or from the front speakers if
CENTER –– was selected for the center speaker
setting.
• This setting works only with dual mono encoded
Dolby Digital or DTS soundtracks. See the disc
packaging for channel information.
Input attenuator setting
When playing analog sources, if the sound is distorting
(or when you see the OVER indicator light in the display),
switch on the input attenuator. Each input has its own
attenuator setting; set it for the currently selected input.
• IN. ATT OFF – Input attenuator is off
• IN. ATT ON – Input attenuator is on
Coaxial input setting
Specifies which receiver function the coaxial input
(DVD(STB) COAX jack) relates to:
• COAX DVD – Assigns the input to the receiver's DVD
function
• COAX STB – Assigns the input to the receiver's STB
function (the optical input is automatically set to
DVD)
Note
• See also Connecting your equipment on page 9.
Optical input setting
Specifies which receiver function the optical input
(STB(DVD) OPT1 jack) relates to:
• OPT1 STB – Assigns the input to the receiver's STB
function
• OPT1 DVD – Assigns the input to the receiver's DVD
function (the coaxial input is automatically set to
STB)
Note
• See also Connecting your equipment on page 9.
• You cannot assign the other optical input (DVR/TV
OPT2 jack).
38
En
AV Direct setting
The AV Direct mode allows the receiver to pass audio/
video signals arriving at one of the AV connector inputs
to the other AV connector outputs without the sound
being routed to the speakers. (See also The AV Direct
mode on page 10.) In AV Direct mode, the current input
is shown (at reduced brightness) in the front panel
display.
The AV Direct setting determines whether the receiver
switches to AV Direct mode automatically, or only when
you switch it manually.
• AVD MANU – Allows you to switch between standby
and AV Direct mode using the AV DIRECT button on
the remote control.
• AVD AUTO – Automatically switches to AV Direct
mode when an incoming signal is sensed by the
receiver in standby.
Auto input select setting
Specifies how the receiver responds when it senses that
a component connected to one of the SCART AV
connectors is switched on.
• SEL MANU – You must select the receiver's input
manually using the front panel INPUT SELECTOR, or
the input buttons on the remote control.
• SEL AUTO – When a component connected to one of
the SCART AV connectors (except the DVR/TV) is
switched on, the receiver automatically switches to
that input.
Note
• When set to AVD AUTO, if a connected component
is switched on, you cannot switch this receiver into
standby (INPUT ON appears in the display).
• You can't use the sleep timer when the AV Direct
setting is AVD AUTO (see also Using the sleep timer
on page 34).
• When AV Direct is on, EON is switched off (see also
Enhanced Other Network (EON) on page 33).