Connecting A Dvd Player - Pioneer VSX-C502 Mode D'emploi

Connecting your equipment

Connecting a DVD player

Follow the instructions below, referring to the diagram, to
connect a DVD player.
If your DVD player has multichannel analog audio
outputs you can connect them to the AUDIO IN (5.1CH)
jacks on this receiver. Connecting these can be useful as
some discs do not allow digital output from the player. It
can also be useful if you want to use an external digital
decoder unit.
1 Use a SCART cable to connect the DVD IN AV
connector to an AV connector on your DVD player.
2 If your DVD player has multichannel analog
outputs, connect these to the SURROUND L / R,
CENTER and SUBWOOFER jacks on this receiver.
These connections are shown in 2 in the illustration
below.
VSX-C502
.
ANTENNA
AM LOOP
+
–
SURROUND
R L CENTER R L
SUB STB
FRONT SURROUND
BACK
SPEAKERS (DVD)
WOOFER
OUT OPT1
3
2
COAXIAL
OPTICAL
DIGITAL AUDIO OUT
DVD player
3 Use a coaxial digital audio cable to connect the
DVD(STB) COAX jack to a coaxial digital audio
output on your DVD player.
This connection carries stereo and multichannel digital
audio.
If your DVD player doesn't have a coaxial digital audio out
jack, it is possible to use an optical connection to the
STB(DVD) OPT1 jack. However, since by default this
input is assigned to the STB input, you will need to
reassign it to the DVD input before you can use it. After
connecting up everything else see Optical input setting
on page 38 for how to do this.
Note
• To listen to multichannel analog audio you'll need to
switch the input signal selector to DVD 5.1ch
(multichannel analog). See Selecting the input signal
type on page 34.
OUT
FM UNBAL 75Ω
IN
CONTROL
CENTER SURROUND
VIDEO IN/OUT
AV CONNECTOR
DIGITAL IN
L
R
DVR/TV DVD SUB WOOFER
(STB)
AUDIO IN (5.1CH) DVD IN
OPT2 COAX
VIDEO
CENTER
L
R
SUB W. SURR. FRONT
AV CONNECTOR (RGB) - TV/AV Receiver
AC IN
DVR/TV IN/OUT
STB IN
1
03
11
En